designer bathroom

Bathroom renovations can be costly. Even if the scope of the task is not big, the expertise of professional bathroom renovators costs a lot in this market. Which is why homeowners must know the basics of conducting bathroom renovation in Sydney. Here’s a step by step guide. 

Planning Process

Firstly, you will have to assess the scope of the task. Examine which fixtures, vanities, etc. need to be replaced. Visualise your bathroom and come up with new design patterns. Your plans shouldn’t exceed your vision. 

However, there’s plenty of room to be creative and explore the various design types. Start over from scratch and keep a minimalistic design in mind. By doing so, you can add fixtures or vanities in the future. An important aspect of bathroom renovation in Sydney is space management. Make sure your bathroom is not crammed and has enough space for free movement. You’ll also have to settle on colour schemes, storage space and create a list of all the fixtures that need replacing. 

What Will You Need?

Here are some must-have tools before you venture into this DIY project –

  • Extension cords
  • Utility knives
  • Flathead screwdriver
  • Wrench
  • Chisel
  • Power drill
  • Stud finder
  • Spackle knife
  • Duct tape
  • Hammers
  • Silicone sealant
  • Safety mask

If you don’t know how to use any of these tools, advanced renovation may be too difficult for you. In that case, contact an expert on bathroom renovation in Sydney to assist you. 

Clear Up and Demolish Old Bathroom Fixtures

Once you’ve gathered your set of tools, it is time for you to clear your bathroom of all fixtures, vanities, etc. Even the items you plan to keep, remove them so that the renovation process doesn’t dirty/damage them.

Get rid of old and damaged fixtures. Demolish them with a chisel and a hammer. Make sure to carry out this process carefully as you don’t want to cause any damage to your bathroom walls. 

Install Shower, Tub and New Fixtures

This process depends on the bathtub. If you have a traditional inset tub, this process will be easy. But, freestanding bathtubs need their plumbing to be hidden under a panel. Plus, these tubs are expensive, so it is best to contact an expert provider of bathroom renovation in Sydney. Your bathroom will have Ground Fault Circuit Interrupters (GFCIs) and other power arrangements pre-installed. To accommodate your new fixtures, you will have to restructure your bathroom’s wiring structure. Consult an electrician to help you with this process/ 

Tiles and Drywall

Up next are two dull yet extremely important steps – layout your tiles carefully so that there’s no room for misalignment. Then, hang up your brand new drywall and paint your bathroom. 

Install Cabinetry and Vanities

Once your tile floors are dried up, install all the cabinets and the vanities. Focus on installing the sink, the countertop and the faucet first. Once these fixtures are all hooked up to your drainage system, you can focus on the other items. 

Lastly, but most importantly, you’ll have to make sure that there is no form of leakage by hooking up all the plumbing lines. If you still have problems, contact a provider of bathroom renovation in Sydney to take a second look.