concrete footpaths

Do you want to install concrete footpaths around your property? If you don’t want to hire professional services for the job, you can try to do it on your own. This is a DIY project, all you need to do is go about things carefully. We will offer you some tips that will help you build concrete footpaths in the best way possible. Let’s get into the details of these tips: 

Overbuild Your Forms 

The first thing that you need to make sure about concrete footpaths is to overbuild your forms. You don’t want to suffer from a horror story in the times to come. You can use normal forms on the curves and use 1-1/2-in.-thick boards otherwise. If you’re using boards of 2x4s or 2x6s, the stakes need to be installed not more than 5 feet apart. Also, you have to pay good attention to the forms if they extend below ground. You need to pack soil against these forms. 

Keep Stakes Below The Form Tops

Another crucial thing to keep in mind while installing concrete footpaths is that you need to keep stakes before the form tops. Stakes that project above forms create a hurdle for your screed board. You need to wait for 5 minutes before you pour so that no protruding stakes take place. If the tops of your forms are near ground level, make sure your screed board won’t drag against the ground. 

Ordering More Than Enough 

When you build concrete footpaths, you might have a particular quantity of material in your mind that you want to install. If you order exactly the quantity that would be enough, it might just not be enough. The thing is, you’re unprofessional in this field. So you may end up wasting a lot of material. This is why you need to order more material than required. So before you build concrete footpaths, keep this point in your mind. 

Plunge Out The Bubbles 

When you pour concrete to build footpaths, air pockets might get trapped in the process. It will leave a void all over the vertical surfaces. You have to plunge out these bubbles so that you don’t face any problems on concrete footpaths later. You just have to grab a 2×4 and “plunge” all along the forms. If it’s still not enough, you can use a hammer and tap the sides of the footpath. These bubbles might not matter on sidewalks or driveways. But you have to be more cautious while you install concrete on stairs, curbs or walls. 

Avoid Too Much Water 

While building concrete footpaths, you should not use too much water. You just have to see if the concrete is too dry to flow down the chute. But if you add extra water, it will lead to a bad mix. If you don’t want to have a weaker slab, you should use just enough water. 

So these are a few important things to keep in mind before you build concrete footpaths. As we told you, it is a DIY project. You just need to go about things very cautiously!